2003012 - Totem shower

2003012

Dimensions product:

Height              :220 cm / 86,61 inches

Lenght              :200 cm / 78,74 inches Weight  :  65 cm / 25,59 inches

 

Dimensions shipping carton:

Height              :230 cm / 90,55 inches

Lenght              :210 cm / 82,68 inches Weight  :  75 cm / 29,53 inches

Packaging weight:        n.b kg

 

Complete including:

4x showers

4x((push) taps / knobs

4x flexible water supply (only cold) -Attention! Automatic mixing or water (pressure) control not included.

 

Material specification:

This product is made of 5 to 6mm thick polyester, and is coated with a matt varnish. With this coating the product is resistant against all kinds of cleaning materials. We use the same coating on our products as been used in the car industry, so you can clean our products just like a car. (do not use

an abrasive sponge) Also you can clean our  products with water pressure.

 

Important tips for installation: 

  • Let your installation be performed by a specialised installation company.
  • After mounting the product, put some putty around the product so water and dirt gets no chance to get beneath the product, also for extra reinforcement. 
  • Make sure that there are 4 connection hoses coming out of the floor with a connection of 1/2” 
  • Automatic mixing control system not included. (totem only one connection x 4 for mixed water).
  • Drill the holes for the totem before you install the product. Mark the holes only when the totem is standing on his place.

 

Assembly procedure:

  1. Place the totem on his place, over the 4 water connection hoses
  2. Mark the mounting holes on the floor through the steel plate.
  3. Take the totem away and drill the holes and place plugs in the floor
  4. Place the totem back on his place and then lay the totem on it’s side so you can attach the water supply to the product. (from the floor to the totem)
  5. Turn the totem back up above the water hoses, and mount the steel plate to the floor.
  6. After mounting the product, put some putty around the product so water and dirt gets no chance to get behind the product.