2009001 - Palm-tree shower


Dimensions product:

Height excl. leaf:           155,00 cm / 61,02 inches

Height incl. leaf:           184,00 cm / 72,44 inches  


Bottom tree-trunk:         ø41,00 cm / 16,14 inches

Top tree-trunk               ø16,50 cm / 6,49 inches

Top tree incl.coconuts:  ø38,00 cm / 14,96 inches

Lenght with leaf:            168,00 cm / 66,14 inches


Dimensions shipping carton:

 (wooden box)

Height              :           200,00 cm / 78,74 inches

Wight                :           50,00 cm / 19,68 inches

Lenght              :           50,00 cm / 19,68 inches

Packaging weight:      ±70 kg / 154 lbs


Complete including:

3x Showerhead. 

3x (push) taps / knobs.

3x flex water supply.

-Attention! Automatic mixing or water (pressure) control not included.


Material specification:

This product is made of 5 to 6mm thick polyester, and is coated with a matt varnish. With this coating the product is resistant against all kinds of cleaning materials. We use the same coating on our products as been used in the car industry, so you can clean our products just like a car. (do not use an abrasive sponge) Also you can clean our products with water pressure.


Important tips for installation: 

  • Let your installation be performed by a specialised installation company.
  • After mounting the product, put some putty around the product so water and dirt gets no chance to get beneath the product, also for extra Make sure that there are three connection hoses coming out of the floor with a connection of 1/2” 
  • Automatic mixing control system not included. (plam-tree only one connection for mixed water).
  • Drill the holes for the palm-tree before you install the product. Mark the holes only when the palm-tree in standing on his place.


Assembly procedure:

  1. Place the palm-tree on his place, over the 3 water connection hoses
  2. Mark the mounting holes on the floor through the steel plate.
  3. Take the palm-tree away and drill the holes and place plugs in the floor
  4. Place the tree back on his place and then lay the tree on it’s side so you can attach the water supply to the tree. (from the floor to the tree)
  5. Turn the palm-tree back up above the water hoses, and mount the steel plate to the floor.
  6. After mounting the product, put some putty around the product so water and dirt gets no chance to get behind the product.